Table of Contents
Advertisement
300918- 08-13-02.qxd
SPECIFIC SAFETY RULES AND SYMBOLS
1.
ALWAYS USE PROPER GUARD WITH GRINDING WHEEL. A guard
protects operator from broken wheel fragments.
2.
ACCESSORIES MUST BE RATED FOR AT LEAST THE SPEED
RECOMMENDED ON THE TOOL WARNING LABEL. Wheels and other
accessories running over rated speed can fly apart and cause injury.
3.
HOLD TOOL BY INSULATED GRIPPING SURFACES WHEN
PERFORMING AN OPERATION WHERE THE CUTTING TOOL MAY
CONTACT HIDDEN WIRING OR ITS OWN CORD. Contact with a "live"
wire will also make exposed metal parts of the tool "live" and shock the
operator.
4.
ALWAYS USE AN APPROVED GUARD with any accessories that
require a guard (see ACCESSORIES Section of this manual).
5.
INSURE THAT THE TOOL IS DISCONNECTED FROM THE POWER
SOURCE AND THAT THE SWITCH IS IN "OFF" POSITION before
replacing or adjusting the guard.
6.
USE PROPER SAFETY EQUIPMENT. Wear safety goggles to protect
your eyes and wear a protective mask to minimize breathing in the fine dust
created while sanding. NOTE: Some wood contains preservatives which can
be toxic. Take extra care to prevent inhalation and skin contact when
working with these materials.
7.
SANDING OF LEAD-BASED PAINT IS NOT RECOMMENDED. Lead-
based paint should only be removed by a professional.
8.
DO NOT INSTALL WOODCARVING BLADE on this grinder.
9.
Some wood contains preservatives which can be toxic. Take extra
care to prevent inhalation and skin contact when working with these
materials. Request, and follow, any safety information available from your
material supplier.
10.
WARNING: There are certain applications for which this tool was
designed. Porter-Cable strongly recommends that this tool NOT be modified
and/or used for any application other than for which it was designed. If you
have any questions relative to its application DO NOT use the tool until you
have written Porter-Cable and we have advised you.
SYMBOL
V
.......................... volts
A
.......................... amperes
Hz
.......................... hertz
W
.......................... watts
kW
.......................... kilowatts
µF
.......................... microfarads
l
.......................... liters
kg
.......................... kilograms
N/cm
2
.......................... newtons per square centimeter
Pa
.......................... pascals
h
.......................... hours
min
.......................... minutes
s
.......................... seconds
9/13/02
3:25 PM
Page 4
DEFINITION
4
Technical Service Manager
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
Advertisement
Table of Contents
