Assembly; Tools & Materials; Unpacking The Stove; Install Anchor Bracket - Jøtul F 370 Installation And Operating Instructions Manual

Jøtul F 370 U.S. 10036803_P12

5. Assembly

If the Rotation Kit will be installed, use the assembly
instructions provided with that kit.
5.1 Tools & Materials
• work gloves
• tape measure
• power drill w/ 1/4" and 3/8" drill bits
• 3/8" or 10 mm open end or socket wrench
• 9/16" or 14 mm socket wrench
• ball peen hammer (Rear Exit connection only)

5.2 Unpacking the Stove

This product includes three boxes shipped on two pallets:
• 351006 Pedestal Assembly
• 351005 Firebox Assembly - attaches to the Pedestal
Assembly
- includes a decorative Flue Outlet Cover Plate (for use
with a rear exit chimney connection), two cast iron Burn
Plates, and a stove mitt inside the Ash Pan.
• 157373 Anchor Bracket / Outlet Adaptor Kit
THE PEDESTAL AND FIREBOX ASSEMBLIES ARE HEAVY!
Be sure to have assistance available when assembling
and installing this stove.
Inspect each assembly and immediately report any
damage to your local dealer.
1. From the bottom of the Pedestal Assembly, remove
and discard the foam doughnut gasket. Also remove
the bolt package from the pallet. These will not be
used in the U.S. and Canada.
2. From the Firebox Assembly:
Remove the Air Outlet Grille and Top Plate from the
stove. These simply lift off the main body.
Remove the Baffle Plate, both Side Panels, Rear Panel,
Shaker Grate, Bottom Plate, and Ash Pan from inside
of the firebox. See fig. 21 and parts list on pages 21-22.
3. Only if the Rear Exit flue connection is to be used:
• Drill a hole at the two dimple locations in the cut-
out panels at the back of the stove (fig. 10, A).
• Place the wooden wedge (fig. 10, B) supplied in the
firebox as shown to support the side plates when the
outlet cut-outs are removed.
• Use a ball peen hammer to knock out the panels
from the back of the stove.
12
• safety glasses
• 4 mm hex key
B
Figure 10. Removing the rear exit outlet knock-outs.
5.3 Attach the Anchor Bracket to the
Pedestal Base
1. Use a 4 mm hex key to remove the two countersunk
screws and cover plate from the pedestal base. See fig. 11.
2. Place the pedestal on its side and use the two,
M6 x 20 mm hex bolts to install the anchor bracket to
the underside of the base plate as in fig. 12.
Figure 11. Remove cover plate from the pedestal base.
A
C
Cover Plate