Setting The Time And Date - ADEMCO AVR960SV Instruction Manual

SETTING THE TIME AND DATE

Use the CLOCK SET display to set the date and
time.
TIME (HOUR, MINUTE, SECOND)
DATE (MONTH, DAY, YEAR)
DAY OF WEEK: Corrected
C LOCK SET
1– 0 1–01 MON
2 1 : 0 0 : A
O PT I O NS
O SD TYP : E FULL
T I ME ADJ US T : SLAVE
TIME ADJUST (MASTER or SLAVE)
OSD TYPE (OFF, FULL or HALF)
CLOCK SET Display Format Description
1. Press the START/STOP button so that [CLOCK
SET] flashes on/off.
2. Press the SET button. The month flashes on/
off.
3. Press the UP or DOWN button until the desired
number appears on the monitor.
4. Press the SET button. The day flashes on/off.
5. Press the UP or DOWN button until the desired
number appears on the monitor.
6. Press the SET button. The year flashes on/off.
7. Press the UP or DOWN button until the desired
number appears on the monitor.
8. Press the SET button. The hour flashes on/off.
9. Press the UP or DOWN button until the desired
number appears on the monitor.
Remember to watch the AM/PM indicator when
setting the hours.
10. Press the SET button. The minutes flash on/off.
11. Press the UP or DOWN button until the desired
number appears on the monitor.
12. Press the START/STOP button: the seconds will
start counting and the clock will start. [CLOCK
SET] will flash on/off again at this time.
13. To display the time/date you have set here on
the monitor screen, press the START/STOP but-
ton again to cause [OPTIONS] to flash, and then
proceed with step 2 in item on OSD TYPE on
page 17.
14. Press the START/STOP button three times.
• Make sure that letters [CLOCK SET] or
[OPTIONS] are not flashing.
Notes:
• Perform the same procedure as when setting the
• To record time and date on the tape, display
automatically to
match the input
date.
time and date to make corrections after having
set them. The minutes flash on/off when the
SET button is pressed (in step 2 above).
them on the monitor screen. If they are not dis-
played on the monitor, they cannot be recorded
on the tape.
16