Table of Contents
Advertisement
Y/C (S) VIDEO CONNECTION
Use S-connector cables when connecting a camera
and a monitor to this VCR.
Note: Long cable runs to distant cameras may
cause signal deterioration and/or sync discrep-
ancies. If these problems occur, use video line
amplifiers and/or cameras having phase-adjustable
line-locked vertical sync.
Y/C (S) Connectors
r
e
Pin No.
w
q
Key
VIDEO CAMERA/RECORDER
(with S video output jack)
CAMERA
(with S video output jack)
SWITCHER
(with S video output jack)
To record the video signal using the Y/C (S)
VIDEO IN jack, specify "VIDEO INPUT: Y/C"
on the SELECTION MENU 1 screen. (See
page 20)
Function
q
Y Ground
w
C Ground
e
Y Signal
r
C Signal
S-connector cable
To Y/C (S) Video IN*
*
Y/C (S) Video Input
In single camera systems, connect the camera to
the Y/C (S) Video IN terminal on the VCR rear
panel. Use of a 2:1 interlace camera is highly rec-
ommended; otherwise, the monitor will show ver-
tical distortion of the TIME/DATE characters.
In multiple camera systems, connect the switcher
output to the Y/C (S) Video IN terminal. Because
multiple camera systems require synchronization,
use of cameras having line-locked vertical sync or
a genlocked master drive/sync source is highly rec-
ommended. The use of vertical interval switchers
is also recommended.
Y/C (S) Video Output
Connect the monitor to the Y/C (S) Video OUT ter-
minal on the rear panel.
To S Video IN
To Y/C (S) Video OUT*
The Y/C (S) Video IN and OUT terminals on this
VCR are of the screw-in type, but normal plug-
in type plugs can also be connected.
MONITOR
10
Advertisement
Table of Contents
