Setting The Time And Date - ADEMCO AVR24TLAX Instruction Manual

SETTING THE TIME AND DATE

Use the CLOCK SET display to set the date and time.
TIME (HOUR, MINUTE, SECOND)
DATE (DAY, MONTH, YEAR)
DAY OF WEEK: Corrected
[ ]
C LOCK SET
0 1– 0 1–02 TUE
0 : 0 0 :
[ ]
O PT I O NS
O SD TYP : E FUL L
T I ME ADJ US T : SLAVE
TIME ADJUST (MASTER or SLAVE)
OSD TYPE (FULL, HALF or OFF)
CLOCK SET Display Format Description
1. Press the START/STOP button so that [CLOCK
SET] flashes on/off.
2. Press the SET button. The day flashes on/off.
3. Press the UP or DOWN button until the desired
number appears on the monitor.
4. Press the SET button. The month flashes on/off.
5. Press the UP or DOWN button until the desired
number appears on the monitor.
6. Press the SET button. The year flashes on/off.
7. Press the UP or DOWN button until the desired
number appears on the monitor.
8. Press the SET button. The hour flashes on/off.
9. Press the UP or DOWN button until the desired
number appears on the monitor.
10. Press the SET button. The minutes flash on/off.
11. Press the UP or DOWN button until the desired
number appears on the monitor.
12. Press the START/STOP button: the seconds will
start counting and the clock will start. [CLOCK
SET] will flash on/off again at this time.
13. Press the START/STOP button twice so that
flashing [CLOCK SET] changes to a steady light.
14. Press the PROGRAM button continuously so that
the TIME/DATE display appears.
Notes:
• Perform the same procedure as when setting the
time and date to make corrections after having
set them. The minutes flash on/off when the SET
button is pressed (in step 2 above).
• To record time and date on the tape, display them
on the monitor screen. If they are not displayed
automatically to
on the monitor, they cannot be recorded on the
match the input
date.
tape.
AVR24TLAX (E) QR34283
12