Cassette Tapes - ADEMCO AVR960SV Instruction Manual

CASSETTE TAPES

Videocassettes other than those marked
cannot be used in this VCR.
It is recommended that you use standard grade
VHS video tapes of the following makers:
Maxell TDK
TAPE LIFE
Slower speed operation in time lapse recording
applies stress to video tape.
inspected and, if necessary, discarded after the
total number of complete tape passes (recording
and playback) exceeds the following limits:
Tape Speed
02, 06*, 12, 18*, 24, 30*
48, 72, 120, 168, 240
360, 480, 600
720, 960
00
: HD mode
*
INSERTING A CASSETTE
Note: This is the first step in all VCR operations.
The VCR will not operate without a cassette in
place.
To insert a cassette push the cassette through the
cassette compartment door until the VCR mech-
anism pulls it into the compartment.
The tape-in indicator turns on.
TOP OF CASSETTE
(THIS SIDE UP)
SAFETY TAB SLOT
Tape Insertion Position
REMOVING A CASSETTE
Before removing a cassette: rewind the tape com-
pletely.
To remove a cassette, press the EJECT button. The
cassette will come partially out of the compartment
so you can pull it out.
13
or
Fuji
Tapes should be
Complete Tape Passes
50
25
10
5
2
VIDEO CASSETTE SAFETY TAB
To prevent accidental erasure of recorded material,
remove the safety tab from the lower left corner of
the cassette.
Recording is impossible when the safety tab is
removed.
Notes:
• The TAB indicator lights when a cassette without
its safety tab is loaded.
• To record again on a cassette that has its safety
tab removed, cover the tab hole with tape. In the
TIMER mode, the TIMER indicator will flash on
and off if the cassette is inserted without its safe-
ty tab slot covered or intact.
SAFETY TAB
TO PREVENT
ACCIDENTAL
ERASURE, BREAK
OFF THE TAB
TO RECORD AGAIN,
COVER THE HOLE
WITH TAPE
Video Cassette Safety Tab