ADEMCO AVR960SV Instruction Manual page 13

TIME ADJUST
When two or more of this VCR model are used,
connect via pins i. With only one VCR, specify
TIME ADJUST: MASTER, in [OPTIONS] items on
the CLOCK SET display. Specify TIME ADJUST:
SLAVE (default setting at the factory) for all other
VCRs. Each time "2:00:05" is reached, the VCR set
to MASTER transmits pulses for adjustment to the
VCRs set to SLAVE. When the VCRs set to SLAVE
receive these pulses, their clocks will adjust to the
same time as the clock in the VCR set to MASTER.
Note: Be sure to set only one VCR to MASTER. If
no VCR is set to MASTER, or two or more VCRs are
set to MASTER, the TIME ADJUST function will not
operate normally.
CAMERA SW OUT
Pin o outputs the following signal each time a
one-field image is recorded. You can combine this
with a video camera switcher which can be con-
trolled externally.
The output timing can be specified using the
SELECTION MENU 1 screen.
5±2ms
REC START IN
Recording is started when 5-12V is applied to pin
!0 .
REMOTE IN
This VCR can be remote controlled when the fol-
lowing circuit is connected to pin !3 .
! 3
! 5
STOP PLAY STILL REW
Use the above resistance values ±2%.
REC CHECK IN
Recording can be checked when pin !4 is shorted
to pin !5 during recording mode. The recorded
material is played back for several seconds so that
you can check whether recording is made normally
or not.
4.5~5.5V
0~0.4V
F.ADV F.F MODE UP REC
12