Table of Contents
Advertisement
SETUP (Continued)
SETTING [OPTIONS] ITEMS
OSD TYPE:
The TIME/DATE display was not
designed to appear at the factory. If you wish to
record the time/date together with image, perform
the following procedure:
There are two types of TIME/DATE display: FULL
and HALF.
FULL
DATE
POWER LOSS (IF SENSED)
DAY OF WEEK
12– 0–01
2
PL
TH
U
6 : 2 : 00P 2 0
1
T
L
SECURITY LOCK (IF ACTIVATED)
TIMER (IF ON)
RECORDING SPEED (IN TOTAL HOURS)
TIME
* The ALARM Count Number records alarms from 0 to 99
and then resets to 0 and continues counting.
HALF
DATE
No display
12– 0–01
2
6 : 2 : 00P
1
TIME
OFF
No display
1. Press the START/STOP button twice so that
[OPTIONS] flashes on/off.
2. Press the SET button so that the OSD TYPE: set-
ting flashes on/off.
3. Press the UP or DOWN button to select the set-
ting (OFF, FULL or HALF).
4. Press the START/STOP button again. The select-
ed setting will light.
Note: The position of the TIME/DATE display on
the monitor can be adjusted by using the H-POS
and V-POS button on the front panel.
17
ALARM COUNT*
A
00
TIME ADJUST: When two or more of this VCR
model are connected to pins i TIME ADJUST of
each EXTERNAL INTERFACE jack, the clocks in
both VCRs can automatically be set to the same
time (TIME ADJUST function).
To use the TIME ADJUST function, set one VCR to
MASTER and any others to SLAVE.
1. Press the START/STOP button twice so that
[OPTIONS] flashes on/off.
2. Press the SET button twice so that the TIME
ADJUST: setting flashes on/off.
3. Press the UP or DOWN button to select the set-
ting (SLAVE or MASTER).
4. Press the START/STOP button again. The selec-
ted setting will light.
Notes:
• You can set OSD TYPE and TIME ADJUST after
you have set the date and time.
• The TIME ADJUST function operates only when
the VCRs are turned on. Therefore, turn the VCRs
on around 2:00:05. This function will not operate
if the times on the MASTER and SLAVE VCRs
drift by more than one hour and 30 minutes.
Advertisement
Table of Contents
