Cassette Tapes - ADEMCO AVR24TLAX Instruction Manual

Time lapse
Table of Contents

Advertisement

CASSETTE TAPES

TAPE LIFE
Slower speed operation in time lapse recording
applies stress to video tape. Tapes should be
inspected and, if necessary, discarded after the total
number of complete tape passes (recording and
playback) exceeds the following limits:
Tape Speed
Complete Tape Passes
03, 12, 24
INSERTING A CASSETTE
Note: This is the first step in all VCR operations.
The VCR will not operate without a cassette in place.
To insert a cassette push the cassette through the
cassette compartment door until the VCR mech-
anism pulls it into the compartment.
The tape-in indicator turns on.
TOP OF CASSETTE
(THIS SIDE UP)
SAFETY TAB SLOT
Tape Insertion Position
REMOVING A CASSETTE
Before removing a cassette, rewind the tape
completely.
To remove a cassette, press the EJECT button. The
cassette will come partially out of the compartment
so you can pull it out.
Important
"Avoid using cassette box fabricated out of
transparent material."
This is to prevent occurrence of any incorrect
operation due to sensor's misdetection.
TAPE SPEED and RECORDING TIME
Tape Speed
Actual Rec./Play
Mode
Hours
E-90
E-180
03
1.5
12
7.5
15
24
13.5
27
50
Tape
Recording
Speed
Interval
mm/s
s/Field
3
23.39
0.02
4.68
0.10
2.60
0.18
VIDEO CASSETTE SAFETY TAB
To prevent accidental erasure of recorded material,
remove the safety tab from the lower left corner of
the cassette.
Recording is impossible when the safety tab is
removed.
Notes:
• The TAB indicator lights when a cassette without
its safety tab is loaded.
• To record again on a cassette that has its safety
tab removed, cover the tab hole with tape. In the
TIMER mode, the TIMER indicator will flash on
and off if the cassette is inserted without its safety
tab slot covered or intact.
SAFETY TAB
TO PREVENT
ACCIDENTAL
ERASURE, BREAK
OFF THE TAB
TO RECORD AGAIN,
COVER THE HOLE
WITH TAPE
Video Cassette Safety Tab
TAPE LENGTH
The total recording time at each of the three tape
speed modes depends on the length of the tape
used.
Use the table to select the tape length which gives
the best compromise between tape cost, total
recording time, and elapsed time between pictures.
Number Of
Tape
Rec. Fields
Drive
Fields/s
50
Continuous
10
Continuous (Slow)
5.6
Continuous (Slow)
AVR24TLAX (E) QR34283
Audio
Recording
Yes
Yes
Yes
10

Advertisement

Table of Contents
loading

Table of Contents