Setting Up For Ntp Synchronization; Configuring Remote Control - Samsung SVR-1670 User Manual

Chapter 7. Communication To/From the DVR

7. 3. Setting up for NTP Synchronization

Network Time Protocol (NTP) synchronizes time between devices on network. On a network, a server
provides the base time. The client systems receive the time from that server for synchronization.
Figure 7.3.1 NTP submenu on the Network Setup Menu
Set the options to your preferred settings to confi gure NTP :
Option
Sync With NTP Turns NTP on or off.
NYP Mode The NTP mode indicates the client.
NTP Server Determines whether the NTP server is on a local network or on the Internet. This
Location option is only available if NTP Mode is set to Client.
Sets the IP of the NTP server. Enter either the IP of an NTP server on the local
NTP Local Server
network or the IP of a DVR with its NTP mode set to Server.
IP
This option is only available if the NTP Server Location is set to Local.
Set the synchronization interval; how often you want your system to communicate
Interval
with the server to synchronize the devices.
62
Digital Video Recorder
Setting
SVR-1670
7. 4. Confi guring Remote Control
The SVR-1670 can be controlled remotely by various devices.
Figure 7.4.1 Remote Control submenu on the Network Setup Menu
Option
Designation the keyboard operating all DVR functions with the controller buttons.
Remote Keyboard The default value is 1.
ID NOTE: If one keyboard is connected to several DVRs, it might confl ict with other
channels, so a different value should be set for the keyboard address.
Remote Controller You can control up to 16 DVRs from one remote control by creating unique IDs for
ID each DVR.
Remote
Confi guration Enable or Disable confi guration to system management software.
Setup
Remote Relay Use the system management software to enable or disable the relay controls.
Four serial ports are available for the DVR; two RS-232C ports and two RS-485
Serial Port
ports.
PTZ Setting up PTZ options.
Digital Video Recorder
Setting
63
SVR-1670