Hard Disk Drive Installation - Samsung SVR-1670 User Manual

Chapter 3. Hardware Installation
3. Turn on the hub or router.
4. Turn on the SVR-1670.
To prevent damage to the SVR-1670, wait to turn the power on until after you have connected
the Ethernet cable.

3. 6 Hard Disk Drive Installation

This section describes how to work with a hard disk drive, in the following subsections :
• Installing a Hard Disk Drive
• Enabling a Hard Disk Drive
• Removing a Hard Disk Drive
• Disabling a Hard Disk Drive
Always turn off the SVR-1670 and unplug the power cable before you attach or remove a hard
disk drive. Disconnect any devices that are connected to an external power source.
Installing a Hard Disk Drive
1. Open the upper cover of the product, and then remove the four screws that connect the hard
disk drive bracket and main unit.
Figure 3.6.1 Removing Screws that Connect the SVR-1670 & Hard Disk Drive Bracket
32
Digital Video Recorder SVR-1670
2. Lift up the hard disk drive bracket, and then insert a hard disk. Fasten the disk to the bracket
using the enclosed fi xture screws, as shown in the picture below.
Figure 3.6.2 Inserting Hard Disk to the SVR-1670
3. Reattach the hard disk drive bracket to the SVR-1670 main unit.
Figure 3.6.3 Reattaching Hard Disk Drive Bracket to the SVR-1670
4. Once the bracket is securely attached, connect the SATA cable.
A
B
A B
Figure 3.6.4 Connecting SATA cable
Digital Video Recorder
D
C
C D
33
SVR-1670