Door Alignment - Kenmore 795.5137 Use & Care Manual

DOOR ALIGNMENT

Remove the base grille before adjusting the doors. See BASE
GRILLE INSTALLATION for reference.
Two methods of door alignment are available based on the
amount of adjustment needed and installation requirements.
Type 1
Adjusting tool: flat blade screwdriver
If the freezer compartment door is lower than the refrigerator
compartment door, level them by inserting a flat blade
screwdriver into the groove of the left leveling leg and
rotating it clockwise.
Left leveling
leg
If the freezer compartment door is higher than the refrigerator
compartment door, level them by inserting a flat blade
screwdriver into the groove of the right leveling leg and
rotating it clockwise.
Height
difference
Height
difference
CHANGE FILTER C C PRESS & HOLD
F F
REFRIGERATOR INSTALLATION
Height
difference
Height
difference
CHANGE FILTER F C F C PRESS & HOLD
Right leveling leg
Type 2
Adjusting tools: wrench
Height
difference
Height
difference
C C
CHANGE FILTER F F PRESS & HOLD
Using a ¾" (19 mm) wrench, turn the keeper nut clockwise to
loosen the keeper nut. Using a
adjustment hinge pin clockwise or counterclockwise to level
the refrigerator and freezer door.
After setting the level door, turn the keeper nut
counterclockwise to tighten.
CAUTION: Do not overtight the door adjustment screw.
The hinge pin can be pulled out. (Adjustable range of
height is a maximum of ½" (12.7 mm)).
AFTER LEVELING THE DOOR HEIGHT
Make sure the front leveling legs are completely touching the
floor.
12
/ " (8 mm) and wrench ¾" (19 mm)
5
16
Keeper nut
Wrench
Adjustment
hinge pin
Down
/ " (8 mm) wrench, turn the
5
16
Up