Table of Contents
Advertisement
WHEN YOU MOVE
When you are moving your refrigerator to a new home,follow
these steps to prepare it for the move.
1. Remove all food from the refrigerator and pack all frozen
food in dry ice.
2. Unplug refrigerator.
3. Clean refrigerator, wipe, and dry well.
4. Empty water from the defrost pan.
5. Clean, wipe and dry thoroughly.
6. Take out all removable parts, wrap them well and tape
together so they do not shift and rattle during the move.
Refer to sections in Using Your Refrigerator for removal
instructions.
7. Depending on the model, raise the front of the refrigerator
so it rolls more easily OR screw in the leveling legs all
the way so they do not scrape the floor. See the DOOR
ALIGNMENT section.
8. Tape the doors shut and tape the power cord to the
refrigerator cabinet. When you get to your new home,
put everything back and refer to the REFRIGERATION
INSTALLATION section for setup instructions.
ICEMAKER OPERATION
Personal Injury Hazard
Avoid contact with the moving parts of the ejector
mechanism, or the heating element that releases the
cubes. DO NOT place fingers or hands on the automatic
icemaking while the refrigerator is plugged in.
A newly-installed refrigerator may take 12 to 24 hours to
begin making ice.
Indicator Light
Ice Cube Size
selector button
The icemaker will produce 5 cubes per cycle, approximately
90 cubes in a 24 hour period, depending on freezer
compartment temperature, room temperature, number of door
openings and other operating conditions. If the refrigerator
is used before the water connection is made to the icemaker,
set the power switch to OFF (O). Throw away the first few
batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker
will stop producing ice.
It is normal for several cubes to be stuck together. If ice is not
used frequently, old ice cubes will become cloudy, taste stale,
and shrink.
USE AND CARE
WARNING
Shutoff Arm
Power Switch
WHEN SHOULD YOU SET THE ICEMAKER POWER SWITCH
TO OFF (O)
• When the water supply will be shut off for several hours.
• When the ice storage bin is removed for more than a minute
or two.
• When the refrigerator will not be used for several days.
NORMAL SOUNDS YOU MAY HEAR
The icemaker water valve will buzz as the icemaker fills with
water. If the power switch is in the ON (I) position, it will buzz
even if it has not yet been hooked up to water. To stop the
buzzing, move the power switch to OFF (O) position.
NOTE: Keeping the power switch in the ON (I) position before
the water line is connected can damage the icemaker. You
will hear the sound of cubes dropping into the bin and water
running in the pipes as the icemaker refills.
25
Hide quick links:
Advertisement
Table of Contents
