Table of Contents
Advertisement
ULTRA ICE
Press this button once to activate increased ice
making function. The ULTRA ICE icon on the display
panel will illuminate when activated. The Ultra Ice function
runs the freezer compartment at the coldest settings for a 24
hour period to increase ice making. Press the button again to
cancel the Ultra Ice function.
DOOR ALARM
When either the refrigerator or freezer door is left
open for more than 1 minute, an alarm will sound to
let you know the door is open. The alarm will repeat every 30
seconds until all doors are completely closed. The door alarm
function can be deactivated by pressing the Door Alarm
button.
CONTROL LOCK
This model is equipped with a control lock function that
disables the temperature controls and dispenser pad. To
activate the Control Lock, press and hold the Door Alarm
button for 3 seconds until the Control Lock indicator turns on.
Repeat this procedure to disable the Control Lock.
NOTE: When the Control Lock is enabled, the dispenser pad
and all other buttons are disabled.
FILTER RESET
There is an indicator light for the water filter
cartridge on the dispenser that will blink to indicate it is time
to change the water filter. The water filter usually needs to
be replaced once every six months. After replacing the
filter, press and hold the Filter Reset button for 3 seconds
to turn off the filter status light.
DISPENSER LIGHT
This model is equipped with a white light that
illuminates the dispenser area whenever the dispenser pad is
engaged.
The dispenser area can also be illuminated by a blue
Mood Lamp that can be turned on by pressing the
button.
When the Mood Lamp is activated, the indicator above the
Light button will be illuminated.
USING YOUR REFRIGERATOR
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely before
making final adjustments. It is best to wait 24 hours before
doing this. The initial settings mentioned in CONTROL PANEL
FEATURES section should be correct for normal household
refrigerator use.
The refrigerator control functions as the thermostat for the
entire appliance (refrigerator and freezer sections). The colder
the setting, the longer the compressor will run to keep the
temperature colder. The freezer control adjusts the cold air
flow from the freezer to the refrigerator. Setting the freezer
control to a lower temperature keeps more cold air in the
freezer compartment to make it colder.
If you need to adjust temperatures in the refrigerator or
freezer, start by adjusting the refrigerator and allow 24 hours
for the temperature to stabilize. If it is too warm or too cold,
then adjust the freezer control.
Use the settings listed in the chart below as a guide. Always
remember to wait at least 24 hours between adjustments.
CONDITION/ REASON
ƒREFRIGERATOR section too
warm.
• Door opened often.
• Large amount of food added.
• Room temperature very warm.
ƒFREEZER section too warm/ice
not made fast enough.
• Door opened often.
• Large amount of food added.
• Very cold [55°F (13°C)] room
temperature. (Compressor does
not cycle often enough).
• Heavy ice usage.
• Air vents blocked by items.
ƒREFRIGERATOR section too cold.
• Controls not set correctly for your
conditions.
ƒFREEZER section too cold.
• Controls not set correctly for your
conditions.
17
RECOMMENDED
ADJUSTMENT:
Set the
REFRIGERATOR
control one degree
colder; wait 24 hours
for the new setting
to take full effect
before making another
adjustment.
Set the FREEZER
control one degree
colder; wait 24 hours
for the new setting
to take full effect
before making another
adjustment.
Move items out of
airstream.
Set the
REFRIGERATOR
control one degree
warmer; wait 24 hours
for the new setting
to take full effect
before making another
adjustment.
Set the FREEZER
control one degree
warmer; wait 24 hours
for the new setting
to take full effect
before making another
adjustment.
Hide quick links:
Advertisement
Table of Contents
