Door Alignment; Fan And Fan Motor(Evaporator); Defrost Control Assembly - Kenmore 795.71312.311 Service Manual

https://appliancetechmanuals.com
• Mullion Replacement
1. Connect wire harness.
2. Insert mullion into channel.
Inserting mullion assy' into bracket, door.
3. Assemble 2 screws.

3-3 DOOR ALIGNMENT

<24cu.ft>
If the space between your doors is uneven, follow the
instructions below to align the doors:
Turn the leveling legs (CCW) to raise or (CW) to lower the
height of the front of the refrigerator by using flat blade screw
driver or 11/32" wrench. Use the wrench (Included with the
User Manual) to adjust the bolt in the door hinge to adjust the
height. (CCW to raise or CW to lower the height).
<22cu.ft>
If the space between your doors is uneven, follow the
instructions below to align the doors
With one hand, lift up the door that you would like to raise at
the middle hinge. With your other hand, use pliers to insert
snap ring as shown. Insert additional snap rings until the doors
are aligned.
(Three snap rings are provided with the refrigerator in the Use
& Care Guide packet).

3-4 FAN AND FAN MOTOR(EVAPORATOR)

1. Remove the freezer drawer. (If your refrigerator has an
icemaker, remove the icemaker first).
2. Remove the grille by pulling the grille forward.
3. Remove the Fan Motor assembly by loosening 3 screws
and disassembling the shroud.
4. Pull out the fan and separate the Fan Motor and Bracket.
Shroud

3-5 DEFROST CONTROL ASSEMBLY

Defrost Control assembly consists of Defrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature. At 46F(8°C), it turns the Defrost Heater off.
Fuse-M is a safety device for preventing over-heating of
the Heater when defrosting.
1. Pull out the grille assembly. (Figure 1)
2. Separate the connector with the Defrost Control assembly
and replace the Defrost Control assembly after cutting the Tie
Wrap. (Figure 2)
GRILLE ASSEMBLY
Figure 1
FAN MOTOR
DEFROST-CONTROL
ASSEMBLY
Figure 2