Alpine INA-W900 Owner's Manual page 93

How to use a Seal
If A is used for installation:
Affix the seal so that mounting holes B and C are covered.
If B is used for installation:
Affix the seal so that mounting holes A and C are covered.
If C is used for installation:
Affix the seal so that the mounting holes A and B are covered.
Installing the Face Plate
2
* If A is used, the supplied face plate may be mounted.
If B is used, the face plate must be modified before installing it.
To modify the face plate, consult your Alpine dealer.
If C is used, the face plate cannot be mounted. Consult your Alpine
dealer.
4
Hex Nut (M5)
Metal
Mounting
Strap
Ground Lead
92
-EN
Screw
2
*
Bolt Stud
1
*
This unit
Chassis
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw (*
attached to the vehicle's chassis.
2
• For the screw marked "* ", use an appropriate screw for the chosen
mounting location.
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the INA-W900. Connect all other
leads of the INA-W900 according to details
described in the CONNECTlONS section.
5
Slide the INA-W900 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
This unit
2. Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Take the face plate off, and secure the ground lead of the unit to
a clean metal spot using a screw (*) already attached to the
car's chassis.
Attach the Original Mounting Bracket to each side of the
INA-W900, using the screws supplied with
INA-W900.
Ground Lead
*
Mounting
Bracket
Chassis
1
) already
Bracket keys
(Included)
Screws (M5 × 8) (Included)
Face Plate (Included)