Inserting/Ejecting A Disc; Inserting/Removing The Sd Memory Card; Adjusting The Monitor Viewing Angle; Adjusting The Volume - Alpine INA-W900 Owner's Manual

Inserting/Ejecting a Disc

1
Press on the unit.
The display changes to the Eject/Tilt screen.
2
Insert a disc:
Touch [Open] on the Eject/Tilt screen.
The movable monitor will open, then insert a disc into the
disc slot. Inserting a disc will close the monitor
automatically.
Disc Slot
Eject the disc:
Touch [Eject] of Disc on the Eject/Tilt screen.
The movable monitor will open. Then the disc is ejected.
After remove the disc, touch [Close] to close the movable
monitor.
• Touching [Exit] returns to the earlier main source screen.
• Do not apply shock to the movable monitor when it is open as it may
result in malfunction of the unit.
• The monitor may be dim during low temperature and immediately
after turning on the power. The brightness will return to normal as
time elapses.
• The monitor will stop at the set tilt angle when closing.
CAUTION
Keep hands (or any other object) away from the monitor while it
is opening or closing to avoid damage or injury. The back of the
movable monitor will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.

Inserting/Removing the SD Memory Card

You can update the software and map of navigation system by using an
optional SD memory card. To insert and take out the SD memory card,
follow the instructions below.
1
After opening the movable monitor, open the cover
of SD memory card slot.
Insert the SD memory card
2
Insert your SD memory card until it clicks.
Remove the SD memory card
2
Push the SD memory card that is inserted.
The SD memory card is pulled out.
3
Close the cover of SD memory card slot.
4
Close the moveable monitor.

Adjusting the Monitor Viewing Angle

Adjust the monitor's angle for better visibility.
1
Press on the unit.
The display changes to the Eject/Tilt screen.
2
Touch [ ] or [ ] of Tilt to adjust the desired
monitor angle.
The monitor angle can be adjusted in 5 stages.
3
Touch [Exit] to return to the previous screen.
• If the monitor touches an obstacle while the angle is being adjusted,
it will stop immediately.
• The screen color will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is normal and not a
malfunction.

Adjusting the Volume

Adjust the volume by pressing
Volume decreases/increases continuously by pressing and
holding or .
Volume: 0 - 35

Lowering Volume Quickly

Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
or .
15
-EN