Table of Contents
Advertisement
•
Card remote commander operation is not
possible.
Make sure the insulation film has been removed
(page 4).
DSO does not function.
Depending on the type of car interior or type of music,
DSO may not have a desirable effect.
The disc cannot be loaded.
• Another disc is already loaded.
• The disc has been forcibly inserted upside down or in
the wrong way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 15).
MP3fWMAJAAC files cannot be played back.
The disc is incompatible with the MP3IWMAlAAC
format and version (page 16).
MP3fWMAJAAC files take longer to play back
than others.
The following discs take a longer time to start
playback.
- a disc recorded with a complicated tree structure.
- a disc recorded in Multi Session.
- a disc to which data can be added.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• "A.SCRL" is set to "OFF'.
- Set "A.SCRL-ON" (page 13).
- Press and hold
(DSPl)
(SCRL).
The sound skips.
• Installation is not correct.
- Install the unit at an angle of less than 45° in a
sturdy part of the car.
• Defective or dirty disc.
The operation buttons do not function.
The disc will not eject.
Press the RESET button (page 4).
Radie re~ption
.
.
.
...
,
. . . . .
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna (aerial) control lead (blue)
or accessory power supply lead (red) to the power
supply lead of a car's antenna (aerial) booster (only
when your car has built-in FM/AM antenna (aerial)
in the rear/side glass).
• Check the connection of the car antenna (aerial).
• The auto antenna (aerial) will not go up.
- Check the connection of the power antenna
(aerial) control lead.
• Check the frequency.
• When the DSO mode is on, the sound is sometimes
hampered by noises.
-Set the DSO mode to "OFF' (page II).
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• Setting of the local seek mode is not correct.
- Tuning stops too frequently:
Set "LOCAL-ON" (page 13).
- Tuning does not stop at a station:
Set "MONO-ON" (page 13).
• The broadcast signal is too weak.
- Perform manual tuning.
During FM reception, the "ST" Indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
- Set "MONO-ON" (page 13).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
-Set "MONO-OFF' (page 13).
Error displays/Messages
CHECKING
The unit is confirming the connection of an iPod.
- Wait until confirming the connection is finished.
COM ERR (iPod Communication Error)
Due to incorrect connection, data did not transfer
successfully between the unit and iPod.
- Reconnect the iPod and select iPod.
ERROR
• The disc is dirty or inserted upside down.
- Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play due to a problem.
- Insert another disc.
• iPod was not automatically recognized.
- Reconnect it again.
• Press
~
to remove the disc.
FAILURE
The connection of speakers/amplifiers is incorrect.
-
See the installation/connections manual of this
model to check the connection.
L. SEEK
+/-
The local seek mode is on during automatic tuning.
NO INFO
Text information is not written in the MP3IWMAI
AAC file.
NOIPOD
The iPod is not connected.
- Connect iPod to dock connector.
If "NO IPOD" appears after connecting the iPod to the
dock connector, disconnect the iPod from the dock
connector, then reconnect.
NO MUSIC
The disc/iPod does not contain a music file.
- Insert a music CD in this unit.
- Connect an iPod with a music file in it.
20
Advertisement
Table of Contents
