Names And Functions Of Indicators On Remote Controller - Lennox Swing User Manual

3. SWING Button: Pushing Chis switch button to change the swing angle of louver.
4. RESET Button: When push the RESET button, all the current settings are cancelled and
get into the condition of the beginning.
5. ECONOMIC RUNNING Button: Push Chis button, it is Energy-Saving operation mode.
6. LOCK Button: Push the button, lock all the current settings, and another push, cancel
the LOCK function.
7. CANCEL Button: To cancel the TIMER settings.
8. TIMER Button: This button is used to preset the time ON (start to operate) and the time
OFF (turn off the operation).
9. ON/OFF Button: Push Chis button to start operation, push the button again to stop
operation.
10. FAN SPEED Button: This button is used for setting Fan Speed in the sequence t h t
goes from AUTO, LOW , MED to HIGH, then back to Auto.
11. TEMP Button: Push the button to make the indoor setting temperature increase, or
adjust the Timer in the clockwise direction.
NOTE: VENTILATION Button: push this button to set the ventilating mode, each time
when pushed, the ventilating mode operate as the following sequence:
Continuous
Ventilation Function is optional, only available for the Fresh Star Series.

Names and Functions of indicators on Remote Controller

1. TRANSMISSION Indicator: This indicator lights when remote controller transmits signals
to indoor unit.
2. MODE Display: Show the current operation mode, includes AUTO, COOL DRY and
HEAT.
3. ONLY FOR HEAT PUMP LOCK Display Displayed: By pushing the LOCK button push
the LOCK button again to disappear.
4. TIMER Display: This display area show the settings of TIMER that is if only set the
starting time of operation it will display the TIMER ON,if only set the turning off time of
operation it will display the TIMER OFF, if set both it will show TIMER ON OFF, which
indicate you have chosen to set the starting and off the operation of TIMER.
5. FAN Display: Push the FAN button Chis signal indicator lights.
6. Digital Display: Area as a rule Chis area will show the setting temperature and if on the
TIMER condition it show the ON and OFF settings of TIMER.
NOTE: All items are shown in the Fig.2 for the purpose of clear presenta tion But during
the actual operation only the relative functional items are shown on the display
panel.
Auto Off –
Display Panel
Fig. 2
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
6