Table of Contents
Advertisement
2.2 Remote control (optional)
Connecting the remote keypad to the inverter unit with a dedicated interconnect cable
and a connector (optional) makes it possible to operate the inverter from a distant
point up to 5m from it.
● Never connect the unit to any inverter other than a VF-AS1 series inverter
or any communications device. Do not use any cable other than an
optional interconnect cable designed specifically for the unit.
Prohibited
Failure to observe this might cause the unit to break down and result in an
electric shook or fire.
Turn off the inverter, as shown in the figure below.
<Inverter unit>
Serial RS485
connector (2-wire)
• @
2. Installing the LCD remote keypad
• @ • @
Danger
* The pin configuration of the dedicated interconnect
cable is different from that of any other commercially
available cable.
Therefore, be sure to use the dedicated interconnect
cable.
2-3
Connector (optional)
< Remote keypad >
Dedicated interconnect
*
cable (optional)
Advertisement
Table of Contents
