Troubleshooting - Toshiba B-SV4T SERIES Manual

5. TROUBLESHOOTING

This section lists the common problems that you may encounter when operating the
printer. Also, it provides solutions.
1. The printer is not receiving power.
Turn the power switch on.
Check power connection from both the socket to the power supply and
the power supply to the printer.
2. The printer is on and ready to use.
No action necessary.
3. The printer is paused.
Press the feed button to resume printing.
4. The LED is on red blinking.
If the LED is on red blinking, which means that either label or ribbon runs out.
Label runs out:
Load a roll of label and follow the instructions as following and then press the
feed button to resume printing.
1. Insert a paper roller into a paper roll
2. Open the printer's top cover by releasing the green cover lock tabs located
on each side of the printer and lifting the top cover. A support bar at the
rear of the printer will hold the printer top cover open.
3. Place a roll of paper onto the center of the paper roll mount.
4. Feed the paper, printing side face up, through the Teflon bar and the paper
guide and pass over the platen.
5. Adjust the green center-biased paper guides in or out so they are slightly
touch the edges of the label backing.
6. To close the printer top cover, lift the cover slightly and pull the support bar
forward toward the front of the printer.
and make sure the cover locks latch securely.
Close the printer
5-1
top cover slowly