Address Setup - Toshiba RAV-SM564UTP-E Service Manual

9-1. Address Setup

<Address setup procedure>
When an outdoor unit and an indoor unit are connected and they are twin-triple, or when an outdoor unit is
connected to each indoor unit respectively in the group operation even if multiple refrigerant lines are provided,
the automatic address setup completes with power-ON of the outdoor unit. The operation of the remote
controller is not accepted while automatic address works. (Approx. 4 to 5 minutes)
Setup of line address of outdoor unit,
indoor unit address, and group address
Completion of wiring work
Do you arbitrarily set the
indoor unit address?
YES
(MANUAL)
Connect one remote controller with
one indoor unit (1 : 1) tentatively with
communication wiring.
Turn on power of outdoor unit.
Set to all indoor units one by one.
END
• When the following addresses are not stored in the neutral memory (IC10) on the indoor P.C. board, a test
run operation cannot be performed. (Unfixed data at shipment from factory)
CODE No.
Line address 12
Indoor unit
13
address
Group
14
address
9. ADDRESS SETUP
NO
Is refrigerant line 1 line?
Is group control performed?
Are there multiple units
of twin-triple connections?
NO
Do you change setting after
automatic setting at the first time?
Turn on power of outdoor unit.
After completion of address
(
setup, change is to arbitral
address/group manually.
Data at shipment
0099 0001 (No. 1 unit) to 0030 (No. 30 unit)
0001 (No. 1 unit) to 0064 (No. 64 unit)
0099
Max. value of indoor units in the identical refrigerant line (Double twin = 4)
0000 : Individual (Indoor units which are not controlled in a group)
0099 0001 : Header unit (1 indoor unit in group control)
0002 : Follower unit (Indoor units other than header unit in group control)
NO
(To AUTO address mode)
YES
YES
YES
)
Setup of automatic
(
address finishes within
4 to 5 minutes.
SET DATA range
– 82 –
FILE NO. SVM-13010
YES
NO
NO
Turn on power of outdoor unit.
)