Toshiba RAV-SM564UTP-E Service Manual page 72

Wireless remote controller (A-B selection)
Using 2 wireless remote controllers for the respec-
tive air conditioners, when the 2 air conditioners
are closely installed.
Wireless remote controller B setup
1. Start the air conditioner.
2. Point the wireless remote controller at the
indoor unit.
3. Push and hold button on the wireless
CHK
remote controller by the tip of the pencil.
"00" will be shown on the display.
MODE
4. Push MODE button during
"B" will be shown on the display and "00" will be
disappear and the air conditioner will turn OFF.
The wireless remote controller B is memorized.
"B" Display
"00" Display
PRESET
NOTE
• Repeat above step to reset wireless remote
controller to be A.
• The wireless remote controllers do not
display "A".
• The factory default of the wireless remote
controllers is "A".
• A-B selection can be set with signal receiving
unit.
For the further details, refer to the installation
manual.
pushing .
CHK
FAN
– 72 –
FILE NO. SVM-13010