Maintenance - Sharp AH-AP18KSY Operation Manual

TIMER ON
The unit will turn on automatically according to your
setting.
1
Press the TIMER ON (
and set the time as desired.
• The time setting will change as you press
the button as follows. Hold the button down
to speed through the setting.
0.5h 1.0h 1.5h
• The orange TIMER lamp (
will light.
• The time setting will count down to show the
remaining time.
Select the mode, temperature and fan speed
setting as desired.
• When the temperature is set with the TIMER
ON, the temperature will show in the display
for 5 seconds and then return to the time
display.
• If you do not change the setting, the unit will
operate using the most recent settings.
• The unit will turn on prior to the set time
to allow the room to reach the desired
temperature by the programmed time.
(Awaking function)
NOTE:
• Timer duration can be set from a minimum half
an hour to a maximum of 12 hours. Up to 9.5
hours, you can set in half-hour increments, and
from 10 to 12 hours, in 1-hour increments.
• The latest time setting will be memorized and will
appear on the remote control display the next
time you set the TIMER OFF or TIMER ON.
• The TIMER OFF and TIMER ON can not be set
together. Only the most recent TIMER setting will
be valid.
• While ONE-HOUR OFF TIMER is set, the TIMER
OFF and TIMER ON setting are unavailable.
• If the ONE-HOUR OFF TIMER is set while the
TIMER OFF or TIMER ON is activated, the TIM-
ER ON or TIMER OFF setting will be cancelled.
) button
10h 11h 12h
) on the unit
1
E-9

MAINTENANCE

Be sure to disconnect the power cord from the
wall outlet or turn off the circuit breaker before
performing any maintenance.
CLEANING THE FILTERS
1
Turn off the unit.
2
Remove the fi lters.
1 Lift the open panel.
2 Push the air fi lters up slightly to unlock them.
3 Pull the air fi lters down to remove them.
1
2
3
Clean the fi lters.
Use a vacuum cleaner to remove dust. If the
fi lters are dirty, wash them with warm water
and a mild detergent. Dry fi lters in the shade
before reinstalling.
4
Reinstall the fi lters.
1 Reinstall the fi lters in the original positions.
2 Close the open panel.
2
1
CLEANING THE UNIT AND THE
REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them. It
can cause electrical shock or equipment damage.
• Do not use hot water, thinner, abrasive powders or
strong solvents.
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1
Operate the unit in the COOL mode,
temperature setting 32˚C, for about half a day
to allow the mechanism to thoroughly dry.
2
Stop the operation and unplug the unit.
Turn off the circuit breaker, if you have one
exclusively for the air conditioner.
3
Clean the fi lters, then reinstall them.
MAINTENANCE BEFORE AIR
CONDITIONER SEASON
1
Make sure that the air fi lters are not dirty.
2
Make sure that nothing obstructs the air
inlet or outlet.
3