Installing the Drive
Before installing the drive, please note the following points.
I You will need the following:
• A screw driver of a suitable size to fit the securing screws
for the drive unit.
• The manual for the computer, so you can find the mounting
positions for the IDE controller cable.
I Turn off all peripheral appliances of the computer and the computer
itself, and disconnect their power cords from the wall sockets.
I Discharge any static electricity on your person by touching the
computer covers, etc.
Make sure all peripheral devices of the computer and the computer itself
are turned off, and then remove the cover. Refer to the manual for the
computer for details about removing the cover.
NOTE : There may be sharp edges inside the computer so take care to
" drive bay panel from the computer. Refer to the
1. Remove the 5
manual for the computer for details.
2. Insert the drive unit into the bay. Do not apply excessive pressure to
the cables inside the computer.
3. Secure the drive with the screws provided. If there is not enough
space behind the drive, connect the IDE and other cables before
securing the drive.
NOTE : This is a general installation guide. If your PC hardware appears
different, please consult your hardware manual for installing peripheral