Connecting A Single Camera To A Switcher, Recorder And Monitor - Sony BRC-H800 Operating Instructions Manual

IR SELECT
SYSTEM IN VISCA RS - 422 OUT
SELECT
HDMI OUT MONITOR OUT
SDI 1
Hub with PoE+
power supply
feature
Notes
• When you supply power from a PoE+ power source,
use a network cable of Category 5e or higher.
• When both the AC adapter and PoE+ power supply
are connected, power is supplied through the AC
adapter.
• When power is supplied from PoE+, both the POWER
lamp (green) and NETWORK lamp (green) flash until
the initial verification process is complete
(approximately one minute, depending on the power
supply device).
• When the network camera is powered by a PoE+
power supply, do not route the wiring outdoors.
When you use PoE+ for the power supply, connect the
ground wire.
• If a non PoE+ compatible device is connected, both
the POWER lamp (green) and NETWORK lamp
(green) flash, and the camera won't start.
• When you turn the power off, wait at least 10 seconds
before you turn it on again.
• Use an STP (shielded) network cable.
CAMERA SETUP
1 2 3
1 2 3 4 5 6 7 8
12V
LAN
OSD
ON OFF
LINE OUT
EXT SYNC IN
SDI 2 SDI 1 SDI 2
TERMI-
NATION
ON OFF
Network cable
(commercially
available)
Connecting a single camera to a
switcher, recorder and monitor
Devices equipped with an HDMI input terminal
SYSTEM
SELECT
HDMI OUT
HDMI cable
(not supplied)
Video monitor
Devices equipped with an SDI input terminal
(4K output): BRC-X1000
SYSTEM
SELECT
HDMI OUT
Recorder or monitor equipped with SDI input terminal
The image size (resolution and frame rate) of the signals
delivered through the SDI OUTPUT terminal can be
changed with the SYSTEM SELECT switch.
For details, see "SYSTEM SELECT switch settings"
(page 64).
24
IR SELECT CAMERA SETUP
1 2 3
1 2 3 4 5 6 7 8
12V
IN VISCA RS - 422 OUT LAN
OSD
ON OFF
MONITOR OUT LINE OUT
EXT SYNC IN
SDI 1 SDI 2 SDI 1 SDI 2
TERMI-
NATION
ON OFF
To HDMI input terminal
IR SELECT CAMERA SETUP
1 2 3
1 2 3 4 5 6 7 8
12V
IN VISCA RS - 422 OUT LAN
OSD
ON OFF
MONITOR OUT LINE OUT
EXT SYNC IN
SDI 1 SDI 2 SDI 1 SDI 2
TERMI-
NATION
ON OFF
SDI OUT
Connecting cable with BNC
connector
To SDI input terminal