Table of Contents
Advertisement
Blade Balancing
The following procedure should correct most fan wobble. Check after each
step.
Check that all blade and blade bracket screws are secure.
1.
2.
Most fan wobble problems are caused when blade levels are unequal.
Check this level by selecting a point on the ceiling above the tip of one of
the blades. Measure from a point on the center of each blade to the point
on the ceiling. Measure this distance as shown in Figure 20. Rotate the fan
until the next blade is positioned for measurement. Repeat for each blade.
Measurements deviation should be within 1/8˝. Run the fan for 10
Minutes.
3.
Use the enclosed Blade Balancing Kit if the blade wobble is still
noticeable.
10
Touching Ceiling
Figure 20
Advertisement
Table of Contents
