Working With The Battery - Intelligent PH Series User's Operation Manual

25 Working with the battery

Balance can work, at wish, using only the battery power.
The battery on board is located inside the balance and gives 10 hours of stand alone
operation
1. With the external power supply disconnected, it is possible to switch on or
switch off the balance through the ON/OFF button and work without being
connected to an AC power outlet.
2. When the balance is working using the battery, the symbol of battery with
charge level is displayed on up-right corner of the balance's display. The three
lines all switched on means a maximum level of battery charge, instead when all
three lines are switched off and only the battery symbol is displayed means that
it is necessary to connect the balance to AC power outlet to re-charge the
battery. Failure to do so will damage the battery. This is NOT covered by
warranty.
1. To re-charge the battery, connect the external power supply (supplied) to the
balance. (See Pag.5)
2. When the external power supply is connected, the balance automatically switches
itself on and, after performing the initial test on display, it enters the stand-by mode
showed by a single point in the display. In standby mode also the battery recharge
symbol will remain switched on.
3. The charge level will graduallystep rise until it reaches the maximum level.
However let the battery recharge at least for 8-10 hours before disconnecting the
external power supply from the balance.
NOTE: Battery duration depends also from working mode of the display backlight. To get longer
battery duration, switch off the backlight or set it in AUTO mode.
51