Table of Contents
Advertisement
7. Selection of interface to printer
Selecting the PRINTER mode, the serial output of the balance is set to work with serial
printers.
In this case the printing is effected only when the PRINT button is pressed and with
stable weight. If the stability is not reached within ten seconds, the message
ERROR05 is displayed preceded by a short acoustic signal and the value of the weight is
not sent to the printer.
The connector to be used for the connection is the number 1 (fig.1 pag.46)
8. Connection of the balance with the serial printer
Connect a serial printer to connector 1 to the balance as shown in the following
scheme:
Balance
side
Connector 1
9. If the optional TLP50 printer is used, it will be possible to print both in
and in
mode
labels -mode
Weighing mode and maximum load mode Piececounting mode
12-02-2008
12:00
Weight:
22.000 g
Density determination mode
12-02-2008
12:00
d= 2.80066 g/cm3d
2
4
5
with the following formats:
Input data
Busy signal
GND
12-02-2008
Pcs
100
Weight:
300.000 g
PMU:
3.000 g
Percentage weight mode
12-02-2009
Perc.
Weight: 300.000 g
48
Printer side
continuous-
12:00
12:00
100.0%
Advertisement
Table of Contents
