Bottom Door Seal - GE Spacemaker GSM1800J Series Technical Service Manual

Hook
Hinge
18. Close the dishwasher door.
Caution: The star washer is easily damaged
during removal and should not be reused. Order
a new set of star washers (part number:
WD01X10254).
19. Remove the star washer from the
dishwasher door hinge.
Caution: The
star washer is
easily damaged
and should not
be reused.
20. Remove the hinge pin from the dishwasher
door hinge.
21. Repeat steps 3 through 10 to remove the left-
22. Remove the dishwasher door from the
23. Reverse the above procedure to install.
The bottom door seal prevents water leakage.
The seal is fitted in a pinched metal groove at the
bottom of the dishwasher door.
Removal and Replacement
1. Remove the Door Panel.
2. Remove the Door Assembly (steps 13
3. Grab one end of the bottom door seal and peal
Warning: The pinched metal groove is sharp.
Wear Kevlar gloves when removing or installing
the door seal. Failure to comply may result in
personal injury.
Star Washer
4. Reverse the above procedure to install.
Note: When installing the door, seal make sure it
is seated properly in the pinched metal groove.
Run your finger over the groove to make sure it is
smooth and even for a proper seal.
Pin
– 18 –
side door hinge assembly.
dishwasher.

Bottom Door Seal

through 22 only).
it away from the pinched metal groove.
Pinched Metal
Groove
Tub Seal
Make sure the seal is
properly seated in the
pinched metal groove.