Table of Contents
Advertisement
7.
If ThE INvERTER fUSE BLOWS
Your power inverter is fitted with a fuse, which should not have to be replaced under
normal operating conditions. A blown fuse is usually caused by reverse polarity or a
short circuit within the device or equipment being operated.
If the fuse does blow:
1.
disconnect the device or equipment immediately.
2.
Find the source of the problem, and repair it.
3.
Install a new 15-amp fuse. The fuse can be found on the end of the plug on
the inverter.
4.
Do not tighten the fuse cap too tight; finger tight is sufficient.
inverter. Make sure to correct the cause of the blown fuse before using the
inverter again.
8.
TROUBLEShOOTINg
PROBLEM
LEd does not light, or
inverter does not function.
do not install a fuse higher than 15-amp, as this may damage the
Poor contact at terminals.
Fuse Blown.
Inverter shutdown.
Inverter may not be working
properly.
REASON
• 7 •
SOLUTION
Unplug and reinsert the
12-volt plug.
See "IF ThE INVERTER
FUSE BLOWS" section.
See "LEd INdICATOR
ANd ShUTdOWN
PROTECTION" section.
See Warranty and call
Customer Service 1-800-
732-7764 (hours: 7:00 am
– 5:00 pm CST).
Advertisement
Table of Contents
