If The Inverter's Fuse Blows; Troubleshooting - DieHard 28.71496 Operator's Manual

11. IF THE INVERTER'S FUSE BLOWS

Your power inverter is fitted with a fuse, which should not have to be replaced
under normal operating conditions. A blown fuse is usually caused by reverse
polarity or a short circuit within the device or equipment being operated.
If the fuse does blow:
1. Disconnect the device or equipment immediately.
2. Find the source of the problem, and repair it.
3. Install a new 25 amp fuse. The fuses can be found on the right side of the inverter.
4. Do not tighten the fuse cap too tightly; finger-tight is sufficient.
IMPORTANT: Do not install a fuse higher than 25 amp, as this may damage the
inverter and any product you use with the inverter. Make sure to correct the cause
of the blown fuse before using the inverter again.

12. TROUBLESHOOTING

PROBLEM
Red LED is on, audible
alarm is on, and/
or inverter does not
function.
The red LED is lit and
the green LED is not.
REASON
Poor contact at terminals.
Fuse is blown.
Inverter shutdown.
12V accessory plug or
clips are not making a
good connection to the
battery.
Connections are reversed.
• 12 •
SOLUTION
Unplug and reinsert the
12 volt plug or check
connections at power supply.
See If the Inverter Fuse Blows.
See LED Indicator and
Shutdown Protection.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for a
better connection.
Unplug the charger and
reverse the clips.