GreenWorks 26022 Owner's Manual page 17

MAINTENANCE
IMPELLOR REPLACEMENT
13
• Place the impellor and
shaft back into the front
scoop.
16
• Be sure to route the belt
correctly, as shown.
19
impellor shaft washer and nut
• Replace and tighten the
impellor shaft washer and
nut.
22
• Replace and tighten the
remaining screws and the
nut and washer.
14
• Place the pulley back onto
the impellor shaft.
17
• Replace the 2 spacer
washers on the impellor
shaft.
20
spring
• Place the upper spring into
position and then finger
tighten the cover plate into
place as shown.
23
• Re-install the impellor shaft
nut and washer on the right
hand side, and tighten.
17
15
screw and washer
• Replace the 2 screws and 2
washers onto the impellor.
18
• Replace the pulley support
plate and the 3 retaining
screws.
21
spring
• Place the lower spring
into position and slide the
side cover up using slight
pressure to hold the spring
in place.