Operation - Craftsman 75118 Operator's Manual

To inflate vehicle and bicycle tires:
1. Place 120 Volt Inflator evenly on flat
surface.
2. Connect the Quick-Connect Universal
Valve Adaptor to tire air valve and
push down the Valve Lock Lever to
secure the connection.
3. Plug the power cord into a grounded
120 Volt outlet.
4. Move the On/Off switch to the On
position and the Inflator will begin to
operate. Monitor the PSI on the gauge
to fill your item to desired pressure.
Once you have reached the desired air
pressure, move the On/Off switch to
the Off position.
5. Remove the air hose from your tire air
valve by raising the Valve Lock Lever
up.
6. Unplug the power cord from 120 Volt
outlet.
7. Allow unit to cool.
WARNING: Risk of Flying
Objects/Bursting Objects. Over
inflating tire could cause the tire to
burst or the screw-on valve to pop off
the valve stem and become a
projectile. Use a tire pressure gauge
to ensure an accurate tire pressure
reading, because the pressure gauge
on the unit is for general reference
only.

OPERATION

To inflate sports ball, air mattress,
rubber raft, etc.
1. Place 120 Volt Inflator evenly on flat
surface.
2. Select the appropriate inflation
accessory and insert into the Quick-
Connect Universal Valve Adaptor and
push down the Valve Lock Lever to
secure the connection.
3. Plug the power cord into a grounded
120 Volt outlet.
NOTE: For instructions on how to
use High Flow Inflator/Deflator
Adaptor at this point, see the next
page.
4. Insert the inflation accessory into
desired item you are inflating.
5. Move the On/Off switch to the On
position and the Inflator will begin to
operate. Inflate your desired item to the
correct pressure and move the On/Off
switch to the Off position.
6. Remove inflation accessory from
Quick-Connect Universal Valve
Adaptor by raising the Valve Lock
Lever up.
7. Unplug the power cord from 120 Volt
outlet.
8. Allow unit to cool.
WARNING:
Most sports balls with no initial air will
fill in less than 10 seconds. Watch
sports balls carefully while filling, do
not overfill.
WARNING:
much air pressure causes a
hazardous risk of bursting. Check the
manufacturer's maximum pressure
rating for objects being inflated.
Carefully follow instructions.
11
Risk of Bursting.
Risk of Bursting. Too