Installation - Craftsman 75118 Operator's Manual

HOW TO SET UP YOUR UNIT
Location of the Inflator
Locate the Inflator in a clean, dry and
well ventilated area. The Inflator pump
and housing are designed to allow for
proper cooling. The ventilation
openings on the Inflator are necessary
to maintain proper operating
temperature. Do not place rags or
other containers on or near these
openings.
GROUNDING INSTRUCTIONS
WARNING: Risk of Electrical
Shock. In the event of a short
circuit, grounding reduces the risk
of shock by providing an escape
wire for the electric current. This
Inflator must be properly grounded.
The Inflator is equipped with a cord
having a grounding wire with an
appropriate grounding plug (see
following instructions). The plug must
be used with an outlet that has been
installed and grounded in accordance
with all local codes and ordinances.
1. The cord set and plug with this unit
contains a grounding pin. This
plug MUST be used with a
grounded outlet.
IMPORTANT: The outlet being used
must be installed and grounded in
accordance with all local codes and
ordinances.

INSTALLATION

2. Make sure the outlet being used
has the same configuration as the
grounded plug. DO NOT USE AN
ADAPTOR. See illustration
3. Inspect the plug and cord before
each use. Do not use if there are
signs of damage.
4. If these grounding instructions are
not completely understood, or if in
doubt as to whether the inflator is
properly grounded, have the
installation checked by a qualified
electrician.
WARNING:
IMPROPER GROUNDING CAN RESULT
IN ELECTRICAL SHOCK. Do not modify
the plug provided. If it does not fit the
available outlet, a correct outlet should
be installed by a qualified electrician.
Repairs to the cord set or plug MUST be
made by a qualified electrician.
Extension Cords
If an extension cord must be used, be sure
it is:
a 3-wire extension cord that has a 3-
blade grounding plug, and a 3-slot
receptacle that will accept the plug on
the product
in good condition
no longer than 50 feet, and 16 gauge
(AWG) or larger. (Wire size increases
as gauge number decreases: 14, 12,
10, and 8 AWG may also be used).
9
Risk of Electrical Shock.