NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in
illustration below.
If the probe tube A and B are not sealed, pump will run few minutes
•
and night lights will flash. To correct - open door,re-attach probe and close door.
If the lights continue to flash, your bottle may be empty or there
•
may be an issue with water tube lines.Call 888-828-1426 for assistance.
4.
Plug cord into a properly grounded wall outlet.
Water will be pumped into the hot and cold water reservoirs from the bottle.
•
5.
Turn energy saving switches on back of dispenser to ON.
The red switch controls the heating of water. If you do not want hot water, leave
•
this switch OFF
The blue switch controls the cooling of water. If you do not want cold water,
•
leave this switch OFF.
Notice:
For unit to operate properly the probe head must be seated on the
•
bottle and the door must be fully closed.
It will take up to 3 minutes for the reservoirs to load. During this time the pump
•
will run on and off. This is normal.
Each time you dispense water from the taps, the pump will come on to refill the
•
tanks. This is normal.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
9