SAFETY PRECAUTIONS WARNING To reduce risk of injury and property damage, user must read this entire manual before assembling, installing & operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage. This product dispenses water at very high temperatures. Failure to use properly can cause personal injury.
SAFETY PRECAUTIONS --Electrical Requirements WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock.
Product Self Cleaning Hot & Cold Hidden Bottle Water Cooler With Display Model Number 8LDIECH-SC-WFC-SSF Serial ID Number Date of Purchase IMPORTANT: Do NOT Return Dispenser To Store. If you have a question or problem, please contact 888-828-1426 for assistance.
SPECIFICATIONS Power Supply 5 AMPs Refrigerant Type R-134A Cold Water Power 100Watts Cold Capacity / Peak Hour 1 Gallon / 3.79 L Cold Temp Range 3°C – 10°C / 37.4°F - 50°F Hot Water Power 425 Watts Hot Capacity / Peak Hour 1 Gallon / 3.79 L Hot Temp Range 80°C –...
ASSEMBLY Keep plastic bags away from children. Remove dispenser from packaging. Unpack drip tray and insert into dispenser. Remove protective packaging from around probe. Properly dispose all of packaging. CLEANING PRIOR TO INITIAL USE To remove any odors or dust that may collect during shipment, you must clean dispenser prior to first use.
11. Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser. HOT WATER Remove drain cap and silicon plug. Cool water will immediately flow into the bucket. Several seconds later hot water will dispense. Be mindful to avoid injury.
OPERATION This dispenser is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void if used for any other liquids including coffee, tea, juices, beer or wine. This dispenser has been designed to use water bottles with a 3, 5 or 5.2 gallon capacity.
Page 9
NOTICE: When using a 5 gallon rectangular bottle, slide into place as shown in illustration below. If the probe tube A and B are not sealed, pump will run few minutes • and night lights will flash. To correct - open door,re-attach probe and close door. If the lights continue to flash, your bottle may be empty or there •...
Initial Rinsing of Water Lines This unit has been tested and sanitized prior to packing and shipping. During transit dust and odors can accumulate in the tank and lines. You must dispense and dispose at least one quart of water prior to drinking any water. Dispense Cold Water Note: After setup, it will take 1 hour to get water to maximum cold temperature.
Page 11
Replace an Empty Bottle Notice: When your bottle is empty the dispenser will beep intermittently and the LED nightlights will blink until a fresh bottle is connected. You may also hear a sucking sound when the bottle empties. This is normal and is another way to be alerted that your bottle is empty.
PROPER CARE & CLEANING General Cleaning Perform: As needed Time Required: 5 minutes. Note: Do NOT use abrasive materials or chemical cleaners. Clean cabinet surfaces with a soft cloth and warm soapy water. Wipe dust from back of dispenser to improve efficiency. Remove drip tray assembly by sliding it forward.
Page 13
Remove remaining water from reservoir by dispensing from the cold tap into a pitcher. Step B: Sanitize Probe and Taps In a clean bucket, make a sanitizing solution of 1.5 gallons of tap water and 3 tablespoons of unscented household bleach. Wipe probe and area around all taps with a soft cloth moistened with the sanitizing solution.
Allow the water to fill the empty reservoirs. Wait 10 minutes then turn energy saving switches OFF and unplug the power cord. 9. Place a 2 gallon or larger bucket under the drain plug in the rear of the dispenser. HOT WATER 10.
Page 15
Since the cleaning function Since the cleaning function every 4 hours to be automatic operation time. • 6 times for one Day, time were 12 PM, 4 PM, 8 PM, 12 AM, 4 AM, 8 AM. • Execution since before and after CLEANING function 1 minute, the screen prompt •...
TROUBLESHOOTING Dispenser does not operate. Make sure the power cord is properly connected to a working outlet. • Water is leaking. Bottle may have a leak. Remove bottle and replace with new bottle. • If leak remains, remove probe from bottle and call 888-828-1426 for assistance. •...
LIMITED WARRANTY Electrotemp Technologies Inc., (“Vendor”) warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship.
Page 18
à û ³ Æ £ º Í ø Ï ú Ë µ à ÷ Ê é 8 LDIECH-SC-WFC-SSF(GLACIAL)-English Í ¼ º Å £ º 5 M009433X1 ¼ ¼ Ê õ Ò ª Ç ó £ º 1¡ ¢ ³ ß ´ ç £ º 1 43¡ Á 2 10mm 2¡...