Installation - Glacial 8LDIECH-SC-WFC-SSF User Manual

11. Place a 2 gallon or larger bucket under the drain
plug in the rear of the dispenser.
Remove drain cap and silicon plug. Cool water will
immediately flow into the bucket. Several seconds
later hot water will dispense. Be mindful to avoid
injury.
12. Once the unit has drained, replace the silicon plug
and drain cap.
13. Remove the remaining water from the reservoirs by
dispensing from the cold tap into a pitcher.
Rinsing
14. Repeat steps 2 to 13, but this time using clean tap water. During the rinsing
procedure step 8 only requires 3 minutes or until the pump stops.
15. Complete the installation and operation instructions within this manual. If your water
has an off taste. Do not return to store. Call 888-828-1426 for assistance.

INSTALLATION

1. Place dispenser upright.
2. Locate dispenser on a hard and level surface in a cool shaded location near a
grounded wall outlet.
Notice: Do NOT plug in power cord yet.
3. Position dispenser so the back is at least 4 inches from wall and there are at least 4
inches of clearance on both sides.
4. To minimize vibration and noise, make sure dispenser is level.
Notice: Do NOT plug in power cord yet.
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 888-828-1426 for assistance.
HOT WATER
7