Checking The Speaker Setting; Installing Surround Speakers - Panasonic SC-ZT1 Operating Instructions Manual

Speaker setting
When the speakers are detected, the Wireless Link display lights up on the main unit's
display.
(Blinks during detecting operation.)
While the wireless speakers operate normally, the Wireless Link display lights, but when radio
waves are interrupted (when speakers are in standby condition, etc.), it blinks.
• When you turn the main unit off with the speakers on, the speakers automatically enter standby (Wireless link standby). The
colour of [WIRELESS LINK] indicator turns to red.
• To reduce more of the power consumption of speakers in standby, turn the speakers off. The speakers enter standby (In standby
condition).
<Power consumption of speakers in standby>
Wireless link standby: approx. 0.8 W (per 1 speaker)
In standby condition: approx. 0.15 W (per 1 speaker)

Checking the speaker setting

1. Turn the main unit on.
2. Press [TEST] on the remote
control to output the test signal.
3. Make sure that the display of main unit matches speaker locations.
The test signal is output from one speaker at a time for about 2 seconds in the order shown below.
"TEST L " → "TEST R " → "TEST RS "
Confi rm the correct setting locations in the following chart.
Display
TEST L
TEST R
✽
TEST RS
✽
TEST LS
Note
If the speakers are not properly set, do either of the following.
• Move the speakers according to the unit's display.
• Perform steps 3 and 4 of "Setting the speakers" (➜ page 15). When using the surround speakers, perform steps 7 and 8 of
"Setting surround speakers" (➜ page 17).
4. Press [TEST] on the remote control to stop the test signal.
If the speaker is repaired or replaced
Perform the above "Checking the speaker setting" to confi rm that the speaker properly operates.
Do the following operations if the sound is not produced normally.
1. Press and hold [INPUT SELECTOR] on the main unit approx. 3 seconds until "2CH SEARCH " is displayed.
2. Perform steps 2 to 4 of "Setting the speakers" (➜ page 15).

Installing surround speakers

The surround speakers are not included.
You can enjoy more dynamic surround playback with this system by installing Panasonic surround speakers SB-ZT1.
Setup example
Front speaker
(left)
Connected equipment
Main unit
Surround
speaker
Approx. 120°
(left)
16
RQT9472
Press
→ "TEST LS "
✽
Speaker outputting the test signal
Front left
Front right
Surround right (right back)
Surround left (left back)
Front speaker
(right)
Surround
speaker (right)
• To adjust the speaker volume, press [VOL
✽
✽ Displayed only when using
the surround speakers.
• Place them slightly at the back right and left of the listening-viewing
position.
• There is no positional distinction for each speaker before setting.
• Aim the front face (with Panasonic logo) of each speaker at the listening-
viewing position for setting.
Note
Set the distance from each speaker to the listening-viewing
position. (➜ page 24)
Display
Wireless Link
W
display
+, –].