Setting Distances; Setting 7.1-Channel Virtual Surround; Reducing Standby Power Consumption; (In Standby Condition (Hdmi Off Mode)) - Panasonic SC-ZT1 Operating Instructions Manual

Functions and settings
To return to the previous
display/To cancel during setting
operation: Press [
24
RQT9472

Setting distances

You can make this setting when using the surround speakers.
This setting is not displayed under different conditions.
By setting the distance from front/surround speakers to the listening-viewing position, the
sound delay time is automatically calculated and adjusted so that sound reaches the listener
at the same time.
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. ( ➜ page 23)
2. Press [w][q] to select "DISTANCE " and press [OK].
3. Press [w][q] to select a speaker to set and press [OK].
FRONT : Front speakers
SURR : Surround speakers
4. Press [e][r] to select the distance and press [OK].
Adjustment range: 1.0 to 10.0 m
Factory setting : Front
5. Press [
[OK] to fi nish the setting.
Note
Radio waves from this system reach maximum range of 15 m within the same room.

Setting 7.1-channel virtual surround

When playing back 7.1-channel LPCM signals, you can enjoy wider sound fi eld effects as if
another speaker is added. Factory setting is "AUTO ".
When you do not want to use 7.1-channel virtual surround effect, select "OFF " in this setting.
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (➜ page 23)
2. Press [w][q] to select "7.1CH VS " and press [OK].
3. Press [e][r] to select "OFF " and press [OK].
AUTO : The setting is switched between ON and OFF depending on the input
RETURN].
OFF : 7.1-channel virtual surround is always OFF.
Factory setting : AUTO
4. Press [
[OK] to fi nish the setting.

Reducing standby power consumption

(In standby condition (HDMI off mode))

Standby through function ( ➜ pages 10 and 30) does not work in this mode if you have
connected through the HDMI terminal.
VIERA Link "HDAVI Control" ( ➜ page 20) will not function when this system is off.
1. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. ( ➜ page 23)
2. Press [w][q] to select "HDMI " and press [OK].
3. Press [w][q] to select "STNBY " and press [OK].
4. Press [e][r] to select "OFF " and press [OK].
OFF : Standby power consumption reduced
ON : "Standby through" is activated when this system is turned off. (Normal power
Factory setting: ON
5. Press [
[OK] to fi nish the setting.
3.0 m
Surround 1.5 m
RETURN] several times to select "EXIT " and press
signals.
Only when 7.1-channel LPCM signals are input, 7.1-channel virtual surround
is ON (When other signals are input, this setting is OFF.).
RETURN] several times to select "EXIT " and press
(approx. 0.2 W)
consumption)
RETURN] several times to select "EXIT " and press