Control Guide; Front View; Rear View - Panasonic SC-ZT1 Operating Instructions Manual

Control guide

Main unit (Control box)

Front view

Standby/on switch (8) (➜ pages 15, 18)
Press to switch the unit from on to standby mode
or vice versa. In standby mode, the unit is still
consuming a small amount of power.
Display
When PCM signal is being input
or the input signal setting is fi xed
to PCM (➜ page 26)
General display
DIGITAL : Dolby Digital sources
DTS : DTS sources
VS : When Dolby Virtual Speaker is working
SFC : When SFC mode is being used

Rear view

AC inlet (➜ page 14)
Audio output terminal
(➜ below)
Note
The audio output terminals can be used when you do not use the wireless function and play back on other speakers via an external
amplifi er. Use commercially available monaural audio cables (monaural mini plug/pin plug) to connect to audio input terminals of an
external amplifi er channel by channel.
6
RQT9472
Wireless Link display
(Displayed when wireless speakers are properly operating.)
(➜ page 16)
PCM
DIGITAL INPUT
W
DIGITAL DTS
VS
PL
Digital surround signal/Sound fi eld
(➜ below, page 19)
Subwoofer output
terminal (➜ page 13)
Audio input terminal
(➜ pages 10 to 13)
When input signal is digital
When the input signal setting is fi xed to DTS
SFC
(➜ page 26)
MIX
When the sound fi eld effect is off by
–
pressing [ SETUP, OFF] (➜ page 19) or
when using headphones (➜ page 27)
PL : When Dolby Pro Logic
used (When using Dolby Virtual Speaker
for 2-channel stereo source)
Digital input terminal (➜ pages 10 to 12, 21)
HDMI terminal (➜ pages 10, 11, 13, 21)
For adjusting volume
(➜ page 18)
[INPUT SELECTOR]
switch (➜ page 18)
For connecting
headphones (➜ page 27)
decoder is being