Table of Contents
Advertisement
Checking speaker output
Adjusting speaker output
If you feel the output of the center speaker and subwoofer are not balanced with front speakers adjust the speaker
output according to your preference.
1. Output the test signal. (
2. Press
to select a speaker for adjustment.
SUBW (Subwoofer) → C (Center)
3. Press
•
The test signal comes from the speaker being adjusted.
•
Test signal is output again in above order 2 seconds after adjustment.
4. Press
to stop the test signal.
Note
•
To adjust the front speaker volumes, press [VOL
"Adjusting the balance". (
•
When you select "OFF " for subwoofer adjustment, there is no output from the subwoofer.
•
Even if you adjust each channel level in this adjustment, each channel level setting in each SFC mode does not change.
•
When you make this adjustment, Dolby Virtual Speaker functions. When playing 2-channel sources, Dolby Pro Logic also works
in conjunction. (
pages 26 and 27)
•
You can adjust the speaker level while playing movies and music. (
You can check audio output with a test signal
1. Press
2. Press
3. Press
front speakers to the normal listening level.
•
Test signal is output from one speaker at a time for two seconds in the following
order.
L (Front left) → C (Center) → R (Front right) → SUBW (Subwoofer)
4. Press
Note
Check connections when the speaker does not have output the test signal. (
above step 1 to 3)
to adjust each speaker's output level.
–, +]. To adjust the volume balance of left and right front speakers, see
page 30)
to turn on the system.
to output the test signal.
to adjust the volumes of
to stop the test signal.
page 29)
Speaker
page 8)
Adjustment range:
SUBW:
OFF, MIN,
1 to 19, MAX
C:
6 to
6
23
RQTX0151
Hide quick links:
Advertisement
Table of Contents
