Speaker Setting - Panasonic SC-HT623 Operating Instructions Manual

∫ "Audio" tab
Dynamic Range Compression
Audio during Search
Speaker Setting (‹ below)
Set the delay time for your center and
surround speakers or adjust the
speaker levels.
∫"Display" tab
Menu Language
On-Screen Messages
[Southeast\Asia]and]Singapore]
§5
∫ "Others" tab
FL Dimmer
HighMAT
QUICK SETUP
Re-initialize Setting
This returns all values in the Setup
menus to the default settings.

Speaker Setting

Changing the delay time
(Effective when playing multi-channel audio)
(Center and surround speakers only)
For optimum listening with 5.1-channel sound, all the speakers,
except for the subwoofer, should be the same distance from the
seating position. If you have to place the center or surround
speakers closer to the seating position, adjust the delay time to
make up for the difference.
1
Press [3,4,2,1] to select the delay time
box and press [ENTER].
Center delay time
Exit
Surround delay time
2
Press [3,4] to adjust the delay time and
press [ENTER].
If either distance a or b is less
than c, find the difference in the
relevant table and change to the
recommended setting.
: Recommended placement
L R
C
a
c
SW
b
LS RS
To finish the delay time setting
Press [2] and then [3,4] to select "Exit" and press [ENTER].
≥Off
≥On:
Adjust for clarity even when the volume is low through compressing the range of the lowest
sound level and the highest sound level. Convenient for late night viewing. (Only works with
Dolby Digital)
≥On
≥Off
Delay time
≥Center: 0.0/1.0/2.0/3.0/4.0/5.0 ms
Speaker level
≥Center, Surround (L/R): `6 dB to + 6 dB
§5 ≥ English ≥
≥English ≥ Français ≥Deutsch ≥Italiano ≥Español ≥Português ≥Svenska ≥Nederlands
§6
≥On ≥Off
≥Bright ≥Dim
≥Auto:
The display is dimmed during play, but brightens when you perform some operations.
≥Enable ≥Disable (Unable to use the HighMAT function)
≥Yes ≥No
≥Yes: The password screen is shown if Ratings (➜ page 20) are set. Please enter the same
password. After "INIT" on the display disappears, turn the unit off and on again.
≥No
ms
L R
C
0.0
Exit
SW
Test
ms
LS RS
0.0
a Center speaker
Difference Setting
Approx. 34 cm 1.0 ms
Approx. 68 cm 2.0 ms
Approx. 102 cm 3.0 ms
Approx. 136 cm 4.0 ms
Approx. 170 cm 5.0 ms
b Surround speakers
Difference Setting
Approx. 170 cm 5.0 ms
Approx. 340 cm 10.0 ms
Approx. 510 cm 15.0 ms
≥Surround (L/R): 0.0/5.0/10.0/15.0 ms
[Russia]and]United]Arab]Emirates]
§6
Adjusting the speaker levels
(Center and surround speakers only)
This is one of the ways to get appropriate surround effects. Adjust
the speaker level to the same level as the front speakers.
1
While stopped
Press [3,4,2,1] to select "Test" and
press [ENTER].
Test signal is output from each speaker in clockwise.
ms
L
0.0
Exit
Exit
Test
Test
dB
LS
0
Surround (L)
2
Press [3,4] to select the desired level for
each speaker while test signal is being
output.
≥Center, Surround (L/R): `6 dB to +6 dB
For your reference
You can also adjust the speaker levels during play (➜ page 27).
To finish the speaker level setting
Press [∫ STOP] to select "Exit" and press [ENTER].
Center
dB
R
C
0
SW
ms dB
RS
0.0 0
Surround (R)
RQTC0047
21