Connecting Stb Etc; Setting For Automatically Switching The Input Source To Stb; Connecting Cables To Audio Terminals (Dvd Player, Etc.) - Panasonic SC-ZT1 Operating Instructions Manual

Connecting STB etc.

Use this connection to enjoy STB multi-channel sources on this system.
HDMI IN
HDMI cable
HDMI OUT
Digital audio
STB etc.
out (optical)

Setting for automatically switching the input source to STB

When you make the above connection and you use Panasonic TV (VIERA), you can automatically switch this system's input by
switching the input source of TV (VIERA) to STB in the following procedure.
Preparation: Make sure that this system has been turned on. (➜ page 18)
To return to the previous display/To
cancel during setting operation in
steps 2 to 5: Press [ RETURN].
Note
• "STB AUDIO " in step 3 is displayed only when the unit is connected to the Panasonic TV (VIERA).
Also, this is not displayed when the step 1 operation is not performed.
• If you change the connection after setting, select "OFF " once and "SET " again.
• When you select "EXIT " and press [OK] in step 3, the setting mode finishes.

Connecting cables to audio terminals (DVD player, etc.)

• Refer to the operating instructions for the equipment you are connecting for the correct type of video cable.
TV Audio out
L
R
VIDEO IN
AUDIO IN
: Connect the video cable directly from the other equipment to the television.
A
: Use this connection so audio from the equipment can be heard through the television's speakers even if this system is in standby mode.
B
Reduce the volume on the television and select "TV " after you have made connections as above if you want to use this system.
Digital
audio out
(optical)
1. Switch the input source of TV (VIERA) with the above connection
and show STB pictures.
2. Press and hold [–SETUP, OFF] for about 2 seconds.
The setting items are displayed. (➜ page 23)
3. Press [w][q] to select "STB AUDIO " and press [OK].
4. Press [e][r] to select "SET " and press [OK].
SET : The setting is automatically switched to "AUX2 / STB ".
OFF : The setting is not automatically switched to "AUX2 / STB ". (factory setting)
5. Press [ RETURN] several times to select "EXIT " and press [OK]
to fi nish the setting.
21-pin scart
cable connection
also possible.
AV
• Turn off all equipment before making any connections.
• To connect equipment, refer to the appropriate operating
instructions.
HDMI
input
Make sure to connect
to
TV OUT
Main unit
Video cable ( )
A
Audio cable ( )
B
TV
Blu-ray Disc player/
HDMI Video/
DVD recorder, etc.
Audio out
Main unit
DVD player
etc.
21-pin scart
cable connection
AV
also possible.
VIDEO OUT
AUDIO OUT
11
RQT9472