Related Manuals for Horizon Hobby Focke-Wulf 190A
Summary of Contents for Horizon Hobby Focke-Wulf 190A
- Page 1 Focke-Wulf 190A Instruction Manual / Bedienungsanleitung Manuel d’utilisation / Manuale di Istruzioni...
- Page 2 NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language: The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND little or no possibility of injury.
-
Page 3: Table Of Contents
The Focke-Wulf 190A You are just a few simple steps away from taking fl ight with this impressive replica of one of WW2’s most feared fi ghters of the Luftwaffe. The Focke-Wulf 190A was arguably the most capable fi ghter in the European theatre until the Spitfi re Mk IX took to the skies in 1942. Now you can re-create your own epic air battles ®... -
Page 4: Transmitter And Receiver Binding
Transmitter and Receiver Binding Binding Procedure Reference Table Read the transmitter instructions for binding to a receiver (loca- “Binding” is the process of programming the receiver to recognize the GUID tion of transmitter’s Bind control). (Globally Unique Identifi er) code of a single specifi c transmitter. You need to Make sure the transmitter is powered OFF. -
Page 5: Battery Installation
Battery Installation 1. Push the button (A) into the fuselage, releasing the battery latch. 2. Lift the back of the battery hatch and pull backwards to remove the battery hatch. 3. Install the fully charged battery (B) in the battery compartment with the end of the battery aligned with the rear edge of the foam battery shelf. -
Page 6: E-Fl Ite Retractable Landing Gear
We recommend installing the E-fl ite electric retracts (optional) in the wing before installing the wing on the fuselage. E-fl ite Retractable Landing Gear OPTIONAL (EFLG115, sold separately NOTICE: Always ensure the retracts and wheels are installed so that there Fixed Landing Gear are no obstructions when extending and retracting the struts. -
Page 7: Wing Installation
Wing Installation 1. Remove the battery hatch from the fuselage using the latch button. 2. Turn over the fuselage so the bottom faces up and install the wires and connectors through the hole in the fuselage (A) to the receiver. CAUTION: DO NOT crush or otherwise damage the wiring when attaching the wing to the fuselage. -
Page 8: Drop Tank Installation
Drop Tank Installation IMPORTANT: The included scale drop tank will slow your aircraft much like the auxiliary tank on a full-scale aircraft. NOTICE: NEVER attempt to belly land your aircraft with the drop tank or drop tank support frame installed or damage to the aircraft may result. 1. -
Page 9: Horizontal Tail Installation
Horizontal Tail Installation 1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage. 2. Install the left and right horizontal tails (B) onto the fuselage as shown. Ensure the control horn faces down. 3. Apply 4 pieces of tape (C) to the fuselage mounts (one on the top and bot- tom of each half of the horizontal tail). -
Page 10: Cannon Installation
Cannon Installation NOTICE: NEVER attempt to belly land your aircraft with the cannons installed or damage to the aircraft may result. 1. For scale appearance, install the included cannons by press fi tting them into the leading edge of the wing as shown. Decal installation Your aircraft is supplied with two small Iron crosses for the tail insignia, to be applied as shown. -
Page 11: Control Direction Test
Control Direction Test Move the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. After performing the Control Test, correctly set the failsafe. Make sure the transmitter controls are at neutral and the throttle and throttle trim are in the low posi- tion, then rebind the aircraft to your transmitter. -
Page 12: Dual Rates
Dual Rates Your DSM2/DSMX full range transmitter features dual rates to help you select High Rate Low Rate the amount of travel that you want from the control surfaces. Aileron 12mm up/down 8mm up/down Elevator 10mm up/down 8mm up/down Rudder 25mm left/right 20mm left/right Flying Tips and Repairs... -
Page 13: Drop Tank Fairing Service
Drop Tank Fairing Service 1. If installed, remove the wing from the fuselage, then remove the drop tank support frame and payload mount from the wing. 2. Remove 2 screws (A) from the top of the wing and the drop tank fairing (B). 3. -
Page 14: Ama National Model Aircraft Safety Code
AMA National Model Aircraft Safety Code Effective January 1, 2011 B. RADIO CONTROL A. GENERAL 1. All pilots shall avoid fl ying directly over unprotected people, vessels, A model aircraft is a non-human-carrying aircraft capable of sustained fl ight vehicles or structures and shall avoid endangerment of life and property in the atmosphere. -
Page 15: Troubleshooting Guide
Troubleshooting Guide Problem Possible Cause Solution Aircraft will not re- Throttle not at lowest position or throttle trim too high Reset controls with throttle stick and throttle trim spond to throttle but at lowest setting responds to other Throttle servo travel is lower than 100% Make sure throttle servo travel is 100% or greater controls Throttle channel is reversed... -
Page 16: Limited Warranty
Limited Warranty What this Warranty Covers business hours. When sending product into Horizon, please include your RMA Horizon Hobby, Inc. (“Horizon”) warrants to the original purchaser that the number, a list of the included items, and a brief summary of the problem. A product purchased (the “Product”) will be free from defects in materials and copy of your original sales receipt must be included for warranty consider- workmanship at the date of purchase. -
Page 17: Warranty And Service Contact Information
Compliance Information for the European Union Declaration of Conformity Declaration of Conformity (in accordance with ISO/IEC 17050-1) (in accordance with ISO/IEC 17050-1) No. HH2013041301U1 No. HH2013041302 Product(s): PKZ Focke-Wulf 190A BNF Basic Product(s): PKZ Focke-Wulf 190A PNP Item Number(s): PKZ6250 Item Number(s): PKZ6275 Equipment class:... -
Page 18: Parts Contact Information
Parts Contact Information • Kontaktinformationen für Ersatzteile • Coordonnées pour obtenir des pièces détachées • Recapiti per i ricambi Country of Purchase Horizon Hobby Address Phone Number/Email Address 4105 Fieldstone Rd 888-959-2305 United States of America Sales Champaign, Illinois 61822 USA Sales@horizonhobby.com Units 1-4 Ployters Rd Staple Tye... -
Page 19: Optional Parts
Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionali Part # | Nummer Description Beschreibung Description Descrizione Numéro | Codice PKZ5101 Propeller 10.5 X 9: EXTRA 300 Propeller 10.5 x 9: Extra 300 Hélice 10.5X9 Elica 10.5 X 9: EXTRA 300 Park Flyer Tool Assortment, E-fl... - Page 20 © 2013 Horizon Hobby, Inc. ParkZone, E-flite, Celectra, EC3, DSM, DSM2, DSMX, Z-Foam, Bind–N–Fly, Plug-N-Play and ModelMatch are trademarks or registered trademarks of Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Futaba is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan. All other trademarks, service marks and logos are property of their respective owners.
Need help?
Do you have a question about the Focke-Wulf 190A and is the answer not in the manual?
Questions and answers