Setting Up The Pc - Fujitsu Siemens Computers SCENIC D Operating Manual

Preparing for use

Setting up the PC

When installing your PC, give consideration to the recommendations on video workstation
!
ergonomics in the "Safety and Ergonomics" manual.
Do not expose the PC to extreme environmental conditions (see "Technical data" chapter)
and protect it from dust, humidity and heat.
The space must be at least 200 mm in front of, at the rear and on the right of the casing in
the horizontal operating position, or in front of, at the top and at the rear of the casing in
the vertical operating position so that the device is sufficiently ventilated. Do not cover the
ventilation areas of the monitor and the casing.
The PC can be used either horizontally or vertically. We recommend that you place your equipment
on a surface with good anti-slip qualities. In view of the multitude of different finishes and varnishes
used on furniture, it is possible that the rubber / plastic feet of the devices will mark the surface they
stand on.
Vertical operating position
The vertical operating position is only permissible with the side section and the base feet (available
as an option). The side section holds the base feet securely. The base feet prevent the device from
falling over and ensure proper ventilation.
The set-up direction is specified. The ON/OFF switch must be at the top to ensure
!
sufficient ventilation.
Proceed as follows to prepare the PC for the vertical operating position:
Ê
If you have already operated the PC, switch it off and disconnect all cables from the casing.
Ê
Open the casing (see "Opening the casing" chapter).
Ê
Carefully turn over the casing so that the open top is facing downward.
8
Setting up the PC
A26361-K636-Z100-9-7619