Icom IC-F8101 Instruction Manual page 67

 Scan Set mode
Type
Set the scan type to "Call," "S-Meter," "Voice" or "All
Memory."
CALL: Call Scan. It scans the channels that be-
long to the network group whose scan
type is "Call."
If your station ID is called with a Selcall or
ALE call, the scan stops on that channel
and the voice squelch control function is
activated.
S-Meter: S-Meter Scan. It scans the channels that
belong to the network group whose scan
type is "S-Meter."
If the transceiver detects the signal whose
S-meter level is higher than the Meter
Squelch Level setting, the scan stops on
that channel.
Voice: Voice Scan. It scans the channels that
belong to the network group whose scan
type is "Voice."
If the transceiver detects voice compo-
nents, the scan stops on that channel.
All: All Memory Scan. It scans all memory
channels.
If the transceiver detects signal whose
S-meter level is higher than the Meter
Squelch Level setting, the scan stops on
that channel.
Voice Scan Resume
Set the scan resume function to ON or OFF for an S-
Meter, Voice or All Memory scan, and set the pause
timer to between 5 seconds and 120 seconds, in 5
second steps.
When this setting is ON and a signal is detected, a
scan pauses for this set period, then resumes, or re-
sumes 2 seconds after the signal disappears.
If OFF is selected, the scan pauses until the signal
disappears.
All Memory Scan Speed
Set the scan speed for the All Memory scan to LOW,
MID or HIGH.
(Default: Call)
(Default: 10sec)
(Default: HIGH)
MENU SCREEN
(Default: Call)
(Default: 10sec)
(Default: HIGH)
5
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
61