Icom IC-F8101 Instruction Manual page 33

D Stun call (Only Open Selcall)
The Stun call disables the specified station from either
transmitting and receiving.
• Sending a Stun call
[ ] for 1 second to enter the Network
Hold down
q
selection screen.
Push [r] or [s] to select the desired Network, and
w
then push [ ].
• The Networks that belong to the Open Selcall system
must be selected.
Push r or s to select the Call Type to "Stun."
e [ ] [ ]
• "Selective," "Phone," "Message," "Send Position," "Get Posi-
tion," "Get Status," "Emergency," "Channel Test" and "Stun"
are selectable.
The Get Status call is selectable in the Icom Selcall,
and the Stun call is selectable in the Open Selcall.
Push keypad to enter the Call ID, and then push
r
[ ].
• The previously entered Call ID is displayed.
• Push [t](§) or [u](§§§) to move the cursor.
• Push [8] to delete the digit to the left of the cursor.
• This Call ID is not stored in the Call ID list.
Push keypad to enter the specified station's PIN
t
Code, and then push [
• Push [t](§) or [u](§§§) to move the cursor.
• Push [8] to delete the digit to the left of the cursor.
].
SELCALL/ALE OPERATION
Push r or s to select the Profile, then push
[ ] [ ]
y
.
[ ]
Push r or s to select the Channel.
[ ] [ ]
u
• Only the channels that belong to the selected Network in
step w, are displayed.
• If desired, push [Tests](§§) to transmit the Channel Test
call in this step.
Push to transmit the Stun call. The call is stored
i [ ]
in the Call Out memory.
• While calling, push [PTT] to cancel the call.
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
27