Num Lock After Boot; Memory Test - Acer Altos 9100 Series User Manual

Hard Disk Size > 504 MB
If enabled, BIOS allows you to use a hard disk with a capacity of more than
504 MB. This is made possible through the Logical Block Address (LBA) mode
translation. Other operating systems require this parameter to be set to Disabled .
To prevent data loss, set this parameter set to Enabled if you are using a hard disk
with more than 504 MB capacity that was previously configured through LBA
mode. If you use a hard disk configured through cylinder-head-sector (CHS)
mode, set this parameter to Disabled . The default is Enabled .
Hard Disk 32-bit Access
Enabling this parameter improves system performance by allowing the use of the
32-bit hard disk access.
Windows 3.x, Windows 95, and Novell NetWare. If your software or hard disk
does not support this function, set this parameter to Disabled . The default is
Enabled .
3.2.7

Num Lock After Boot

This parameter allows you to activate the Num Lock function upon booting. The
default setting is Enabled.
3.2.8

Memory Test

When set to Enabled, this parameter allows the system to perform a RAM test
during the POST routine. When set to Disabled, the system detects only the
memory size and bypasses the test routine. The default setting is Disabled .
This enhanced IDE feature only works under DOS,
Chapter 3 - BIOS Utility 3-9