Follow these steps when installing the heat sink and fan to the Pentium II
processor module:
1. Remove the thermal tape protector at the back of the heat sink.
2. Insert the wide clip ends to the wide holes on the processor and the narrow
clip ends to the narrow holes.
Figure 2-6 Inserting the Clip Ends to the Processor Holes
3.
Use a screwdriver to press and lock in the wide end of a clip first. Then
without lifting the screwdriver, point it downward to press and lock the
narrow end of the clip. See Figures 7 and 8 for the illustration of this step.
Chapter 2 - CPU Board 2-9